Request Information
1-part, transparent, medium-viscosity conformal coating with firm, abrasion resistant surface after cure
Unit of Measure

Specifications

Type

 N/A RTV Elastoplastic Conformal Coatings

Product Form

 N/A 1-part RTV cure

Color

 N/A Translucent

Viscosity

 N/A 950 mPa/s

Durometer

 N/A 20 D

Specific Gravity

 N/A 1.377

Room Temperature Tack-Free Time

 N/A 7 min

Room Temperature Cure Time

 N/A 60 min

Heat Cure Time

 N/A 2 min at 60 ºC/15 % RH

Flammability Classification

 N/A 94 V-0

UL 746E Approval

 N/A Yes

Shelf Life from Date of Manufacture

 N/A 36 months

Military Specification

 N/A MIL-I-46058C, Amend. 7

Type, Class, Group

 N/A Type SR, QPL

Dielectric Strength

 N/A 400 V/mil16 kV/mm

Dielectric Constant at 100 Hz

 N/A 2.74

Dielectric Constant at 100 kHz

 N/A 2.74

Dissipation Factor at 100 Hz

 N/A 0.0042

Dissipation Factor at 100 kHz

 N/A < 0.0002

Volume Resistivity

 N/A 5.0E+13 O/cm

Features

N/A
Cures to tough, resilient, abrasion-resistant surface; solvent-borne resin coating; room-temperature cure with optional heat acceleration after solvent flash-off; UV indicator for inspection; UL V-0 flammability rating; Mil Spec 46058C and IPC- CC-830B tested

Potential Uses

N/A
Protective coating for rigid and flexible circuit boards. These one-part, self-priming coatings cure to flexible, transparent elastoplastic coatings ideally suited for electronic printed wiring board (PWB) applications, particularly those requiring toughness and abrasion resistance.

Application Methods

N/A
Applied by spray, brush, flow, dip or automated pattern coating. For spraying operations, solvent dilution of up to 60 % is recommended. For dip coating operations, material may be used as supplied or solvent diluted if a thinner film build is desired. Care should be taken to ensure the solvent is free from moisture and dip tanks should be covered when not in use. For dilution of low VOC coatings, Dow OS-20 Fluid is recommended.

Cure

N/A
The time required to reach a tack-free state can be reduced with heat. When using heat for this purpose, allow adequate time for the solvent to evaporate prior to exposing to elevated temperatures in an air circulating oven. A typical cure schedule for 3 mil (75 micron) coatings is 10 minutes at room temperature, followed by 10 minutes at 80 °C. If the coating blisters or contains bubbles, allow additional time at room temperature for the solvent to flash off prior to oven cure.