Robert Mckeown Co., Inc
111 Chambers Brook Rd.
Branchburg, NJ 08876 US
Phone: 908.218.9000 • Fax: 908.218.8949
Email: sales@robertmckeown.com
|
|
|
Item # Sylgard® 184 Silicone Elastomer, Silicone Potting/Encapsulants
|
|
|
|
|
|
2-part, 10:1 mix, transparent encapsulant with good flame resistance
|
|
|
|
|
|
|
|
10:1 mix ratio; flowable; room temperature or heat cure; high tensile strength; same as Sylgard* 182 Elastomer but with RT cure capability; UL recognized; Mil Spec approved
|
|
|
|
General potting applications: power supplies, connectors, sensors, industrial controls, transformers, amplifiers, high voltage resistor packs, relays; adhe- sive/encapsulant for solar cells; adhesive handling beam lead integrated circuits during processing
|
|
|
|
Supplied as two-part liquid component kits comprised of Base/Curing Agent to be mixed in a 10:1 ratio by weight or volume; automated mixing and dispensing; manual mixing
|
|
|
|
> 48 hours at room temperature
35 minutes at 100 °C (212 °F)
20 minutes at 125 °C (257 °F)
10 minutes at 150 °C (302 °F)
Note: These data were collected on 50–100 gram samples of a lot believed to be typical and should be used as initial estimates of cure times. Times will vary slightly from batch to batch and can be longer or shorter due to thermal mass of your parts and your heating ramp rate. Pretesting is recommended to confirm adequate cure for your application.
For primerless adhesion products, cure time is based on time to reach durometer. Full adhesion may take more time at the cure temperature.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
